ECRESO FM 5kW / 10kW, user manual
–
11/2021
Page 140
WorldCast Systems SAS - 20 avenue Neil Armstrong - 33700 Mérignac (Bordeaux Métropole) FRANCE
+33 (0)5 57 928 928
–
www.worldcastsystems.com
–
contact@worldcastsystems.com
With the scheduler, the transmitter settings can be modified a single time, regularly (every day or every week) or
when triggered by an event.
Enable an instance of the scheduler and set the time and date.
A daily occurrence will take place every day at the set time, starting at the set date. A weekly occurrence will take
place on the week day of the selected date, starting at the set date.
For an event triggered action, select the alarm which will generate the action.
Up to 10 seconds may be necessary between the time the event is triggered and the time of the action.
To set which parameters should be modified, select a preset or a series of commands.
Presets are set on the Transmitter/Main/Preset page.
Select Commands to enter a maximum of 10 serial commands (see chapter 7). Each command including the last one
must be followed by a carriage return (Enter key).
You can for instance enable transmitter presets or change the transmitter’s power every day at the same time, or
change a sound process preset for a weekly show.
Ex:
To lower the transmitter power every night from 1000 W to 750 W, enable two events in the scheduler:
•
The 1
st
event at 6:00 am every day launches the command TX.PWR = 1000
•
The 2
nd
event at 23:00 pm every day launches the command TX.PWR = 750
