ECRESO FM 5kW / 10kW, user manual
–
11/2021
Page 52
WorldCast Systems SAS - 20 avenue Neil Armstrong - 33700 Mérignac (Bordeaux Métropole) FRANCE
+33 (0)5 57 928 928
–
www.worldcastsystems.com
–
contact@worldcastsystems.com
4.4.
With the embedded website
4.4.1.
Network configuration
First set the IP address with the front panel:
From the main screen, press the Check button to display
menus then the down arrow until you see the Network
menu.
Once you see this screen, press the Check button.
The IP address is selected: press the Check button to switch
to edit mode. Use the up and down keys to adjust values by
section, right and left keys to go from one section to the
next. Press the Check button to confirm.
Modify the netmask address the same way as needed.
4.4.2.
Connecting to the web interface
Now the transmitter is set, connect it to the network.
Though the web application is compatible with most browsers, performances vary from one browser to another.
For optimal performances, Google Chrome is recommended.
The browser may display a message indicating that the connection is not certified; however, the site is secured
(data is encrypted) and you may proceed to access it. To prevent these potential blocking and warning messages,
WorldCast Systems now supplies certificates for HTTPS browsing, see section 8.6.5 for more information.
Open a web browser
and enter in the address bar the transmitter’s IP address such as it was set above.
Select the language if necessary.
Enter the user name and password (default:
Admin
/
admin
) and the screen name of your choice. It is used to
communicate with other connected users.
You can now access the web interface.
!
The transmitter must be in remote mode before parameters can be modified. Press the Local button on the front
panel if needed.
