ECRESO FM 5kW / 10kW, user manual
–
11/2021
Page 60
WorldCast Systems SAS - 20 avenue Neil Armstrong - 33700 Mérignac (Bordeaux Métropole) FRANCE
+33 (0)5 57 928 928
–
www.worldcastsystems.com
–
contact@worldcastsystems.com
SmartFM ACTIVATION
(CONF.SFM.STATE)
–
read/write
With this parameter, enable/disable the SmartFM function.
Off/On
SmartFM STATUS
(STAT.SFM.ACT)
–
read
This parameter indicates whether SmartFM is enabled. It may differ from the Activation parameter, if for instance, the
function is enabled but there are no SmartFM credits left.
Off/On
SmartFM STRATEGY / MODE
(CONF.SFM.MODE)
–
read/write
Five broadcasting strategies are available to meet the distinct needs of broadcasters. These strategies may improve
the listening experience for the most sensitive audio signals, especially at coverage limits, dramatically reduce OPEX
without affecting the listening experience, or both.
Standard
: This strategy improves the reception quality while allowing significant savings.
St
: This strategy
increases the “standard”
savings.
Overlap
: this strategy leads to significant savings while protecting from adjacent channels
.
Boost
: This strategy improves the reception quality while controlling the average power. Make sure your
transmitter can reach the set power +10%.
Extreme
: This strategy achieves extreme savings. As minimum impact on the reception quality may be
observed, be careful while using this configuration.
MINIUMUM RATE
(STAT.SFM.MIN)
–
read *
Minimum rate applied to the set power. This rate is contingent on the selected strategy.
From 25 to 125 %
MAXIMUM RATE
(STAT.SFM.MAX)
–
read *
Maximum rate applied to the set power. This rate is contingent on the selected strategy.
From 25 to 125 %
CURRENT RATE
(MEAS.SFM)
–
read *
Rate applied to the set power. It varies between the min rate and the max rate, and depends on the current program.
From 25 to 125 %
SmartFM / SFM POWER
(TX.SFM)
–
read *
SmartFM set power based on the transmitter set power and the applied rate. This value is visible on the
Transmitter/Main/Parameters page of the embedded web site.
SAVINGS
(TX.PCONS.SAVE)
–
read *
This parameter gives the number of kWh saved since SmartFM was first used (on web page and front panel), or over
the last 10 seconds (with serial command). On the web interface, the conversion rate and the currency symbol can be
set (System/Product/Configuration page) to display this parameter as cash value.
