ECRESO FM 5kW / 10kW, user manual
–
11/2021
Page 77
WorldCast Systems SAS - 20 avenue Neil Armstrong - 33700 Mérignac (Bordeaux Métropole) FRANCE
+33 (0)5 57 928 928
–
www.worldcastsystems.com
–
contact@worldcastsystems.com
You’re listening to My Station
You’re listening to My Station
* Strings including ITEM type data can only be sent if the duration is valid. In the above example, after 3 minutes
and 41 seconds and with no new data, “You’re listening to My Station” will be the only string sent.
In addition to all the RT+ commands listed above, and their redefinitions when available, the following commands can
be sent on port 2000 :
PS_TEXT
RT_TEXT
PS_RT_TEXT
TA
TP
PTY
PTYN
DSN
MS
PI
5.18.
SD card parameters
The µSD card is an external storing device meant to mostly stay in place. Removing and setting it back triggers error
messages visible on the embedded web site; it should therefore only be done during maintenance operation
procedures. Unscrew the shield before starting the removal procedure.
These parameters are available as:
Front panel
SD Card menu
see section 6.3.23
Serial commands
SYS.SDC
see section 7.2.1
STATUS
(SYS.SDC.PRES / SYS.SDC.STATE)
–
read
This parameter indicates if the µSD card is present and working properly (OK), not present, ready to be removed
(UNMOUNT) or in fault.
OK, NOT PRES, UNMOUNT or FAULT
EJECT
(SYS.SDC.EJECT)
–
read/write
This parameter requests the removal of the µSD card. Once the command is sent (YES), you must wait for the status to
switch to UNMOUNT before the card is removed. This can only be done locally.
YES or NO
Card removal procedure
•
Unscrew the shield on the front panel of the control unit
•
On the front panel, select the EJECT menu and set to YES
•
Check the STATUS menu is UNMOUNT
•
Physically remove the µSD card
