Maintenance—Periodic Maintenance
Continued on next page
CN93077,000004A -19-06APR20-1/2
Service Intervals
Model:
380GLC
PIN/Serial Number:
Hour Meter Reading:
SERVICE INTERVALS
Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement. For example, at 500
hours also service those items (if applicable) listed under 250 hours, 100 hours, 50 hours, and 10 hours or daily.
FLUID SAMPLING
Fluid samples should be taken from each system at its recommended change interval prior to actually draining the fluid. Regular oil sampling will
extend the operational life of your machine.
As Required
□ Remove and clean fuel tank inlet screen
□ Check and adjust track sag
□ Check windshield washer fluid level
□ Clean rear camera lens—if equipped
□ Check and clean air cleaner dust unloader valve
□ Service exhaust filter
□ Add coolant extender as indicated by COOL-GARD™ II test strips
□ Clean and tighten battery terminals
Every 10 Hours or Daily
□ Check hydraulic tank oil level
□ Check engine oil level
□ Check engine coolant level
□ Lubricate hydraulic coupler—if equipped
Every 50 Hours or Weekly
□ Drain water and sediment from fuel tank sump
□ Drain primary fuel filter and water separator
□ Drain auxiliary fuel filter and water separator—if equipped
□ Lubricate working tool pivots
Every 100 Hours
□ Inspect and re-torque track hardware
Every 250 Hours
□ Check swing gear case oil level
□ Check travel gear case oil level
□ Check pump drive gear case oil level
□ Drain water and sediment from hydraulic tank
□ Check hybrid battery electrolyte level (if equipped)
□ Lubricate front end pin joints
□ Take engine oil sample
Every 500 Hours
□ Take pump drive gear case oil sample
□ Lubricate swing bearing
□ Lubricate swing bearing gear
□ Take diesel fuel sample
□ Drain and refill engine oil and replace filter
□ Take swing gear case oil sample
□ Replace primary fuel filter and water separator
□ Take hydraulic oil sample
□ Replace auxiliary fuel filter and water separator—if equipped
□ Take engine coolant sample
□ Replace final fuel filter
□ Take travel gear case oil sample
□ Check air intake hoses
□ Clean cab fresh air and cab recirculating air filters (replace every
6 cleanings)
Every 1000 Hours
□ Drain and refill swing gear case oil
□ Inspect serpentine belt
□ Replace hydraulic tank oil filter
□ Replace air cleaner elements
□ Replace pilot oil filter
□ Replace air cleaner dust unloader valve
3-2-5
092221
PN=146
Summary of Contents for 380GLC
