20V Cordless Brushless Paint Sprayer EN
11
Category
Type
Capacity
20V Battery
WA3012
4.0Ah
20V Charger
WA3881
2.0A
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
4. CONTROLS AND
FUNCTIONS
Volume knob
Set the material flow by
turning the volume knob on
the trigger of the sprayer
Air flow control
The air flow can be adjusted
from 1-10 by turning the air
flow control.
Trigger
Pull the trigger to deliver
spray material from the
material container to the
nozzle assembly, where it is
sprayed.
WIDE
NARROW
Spray Width Lever
The spray width lever de-
termines the width of the
spray pattern.
Air cap ear
Adjust the spray pattern by
turning the air cap ears.
Horizontal pattern ( ‘up and
down’ spraying motion )
Vertical pattern (‘side to
side’ spraying motion )
5. INTENDED USE
Interior and exterior painting and staining of decks,
outdoor furniture, fences, and walls
6. OPERATING INSTRUCTIONS
NOTE:
Please read the instructions carefully
before use.
ASSEMBLY AND OPERATION
ACTION
FIGURE
BEFORE OPERATION
Material preparation
- Stir the spraying material thoroughly.
- Unscrew the container .
- Fill the material container to desired
level when the material has been appro-
priately thinned**** and strained.
See
Fig. A1,
A2,A3,A4
Turbine assembly
NOTE :
Press and turn lock on/off dial
clockwise to lock on during operation.
See Fig. B1
Suction tube assembly
- Tube end should be facing toward the
front of nozzle if spraying downward
- Tube end should be facing toward the
rear of nozzle if spraying upward
See Fig.
B2
Container assembly
NOTE:
Make sure the container is
tightened firmly.
See Fig.
B3
Material Flow setting
Selecting the right nozzle according
to your work
Use the srewdriver(not supplied) to
take out the nozzle and replace it with
the right one according to your work.
NOTE :
The smaller the diameter of
nozzle is,the more delicate work it can
deal with.
See Fig.
C1,C2,C3
Setting the volume
-Turn the volume knob on the trigger
clockwise to increase the volume.
-Turn the volume knob on the trigger
counter-clockwise to decrease the
volume.
See Fig.
D1
Adjusting the air flow
Turn the air flow control from 1-10
according to your work .
See Fig.
D2
Spray pattern adjustment
Summary of Contents for WX020L
