15
EN
OPERATION MESSAGES
MESSAGE
LANDROID ACTION
Cutting grass
Cutting grass according to the mowing schedule.
Raining
The rain sensor detects water. Landroid will return to the charging station and
stay there for the time you have programmed it to do so. When dry, Landroid will
automatically begin the rain delay countdown and then return to mow. If you want
Landroid to mow before this, simply turn it off then on again, but only when the rain
sensor is dry, or you can remove the rain delay completely by setting the rain delay
time to zero.
Going home
Needs to recharge—during the journey to the base, the cutting blade is stopped in
order to save energy.
Charging
‘Charging’ and charge percentage are displayed.
No working time scheduled
Stand-by, needs to be programmed as desired.
Not working today
Stand-by, will start according to mowing schedule.
Work done today
Zone searching
According to the setting of ‘Customize work zone’, Landroid is searching a certain
area to mow.
Charge complete
Landroid has completed its charging.
Emergency charge
Landroid is charging in a powered-off state.
ERROR MESSAGES
Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in
doubt, please visit our website where you will find useful videos and further support.
MESSAGE
CAUSE
ACTION
Battery pack cover is open
Close the battery pack cover
Outside working area!
Press START to reset.
Landroid cannot find the
boundary wire signal.
1. If Landroid is actually outside of its working area: turn power off, take
Landroid inside the working area, turn the power on and press start.
2. If Landroid is inside its working area check if the LED on the charging
pile is solid green. If red, check if the boundary wire is properly connected
to the charging pile and that the pile is connected to a suitable power
supply. If they are properly connected, the boundary wire terminals are
clamped incorrectly and must be reversed.
WRONG PIN! Please
retry.
PIN code is wrong.
Input the correct PIN or re-set your PIN.
Blade motor fault!
Press START to reset.
Blade disc is blocked by an
object, e.g. a branch.
Turn power off.
Turn Landroid upside down and check if there’s anything preventing the
blade disc from rotating and remove any obstruction.
Turn Landroid upright.
Turn power on. Press start
Blade is over-loaded by
thick dense grass.
Turn power off.
Take Landroid to an area with short grass or adjust the cutting height to a
higher setting.
Turn power on. Press start.
