18
EN
--Inserting the bits
See Fig. B2
-- Assembling the belt hook
See Fig. C1,
C2
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
WARNING:
Never change the
direction of rotation when the
chuck is rotating, wait until it has stopped!
See Fig.D1,
D2,D3
TWO-SPEED GEAR CONTROL
See Fig. E
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING, HAMMER
DRILLING
See Fig.F1,
F2, F3
OPERATING THE ON/OFF SWITCH
WARNING:
Do not operate
for long periods at low speed
because excess heat will be produced
internally.
See Fig. G
LED LIGHT INDICATOR (See Fig. G)
To turn on the light, press the on/off switch and make sure
the forward/reverse rotation control is on right/left position.
When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed
area. LED is also a battery capacity indicator. It will flash when
power gets low.
The tool and battery pack are equipped with a protection
system. When the LED Light is quickly flashing and turn off,
the system will automatically cut off power to the tool to
extend battery life. The tool will automatically stop during
operation if the tool and/or battery pack are placed under
one of the following conditions:
• Overloaded:
The tool is operated in a manner that
causes it to draw an abnormally high current. In this
situation, release the Trigger Switch on the tool and stop the
application that caused the tool to become overloaded. Then
pull the Trigger Switch again to restart.
• Overheated:
Under the condition above, if the tool does
not start, the Tool and Battery Pack are overheated. In this
situation, let the Tool and Battery Pack cool before pulling the
Trigger Switch again.
•
Low battery voltage:
The remaining Battery capacity is
too low and the tool will not operate. In this situation, remove
and recharge the Battery Pack.
6.PROBLEM SOLUTION
(
1
)
WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.Check that the battery is charged and
properly connected to the tool.
(
2
)
THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Summary of Contents for D-LITE WX100
