Lawn Mowing Robot
EN
12
6. Software update
Your Landroid
®
L software can be updated when new versions
become available. The software version will be showed in the
display. The manual in box is based on the default software in the
mass production .Some new features/functions in the new version
may not exist in the manuaL If you found some settings not in
the manual, please visit www.worxlandroid.com. to download the
latest manual. You can check the software version installed on your
machine by pressing the ON/OFF button.
The latest software can be downloaded from our website – see
below download and installation instructions;
Step 1:
Locate the latest software version at : www.worxLandroid.com.
Copy the “.bin” file containing the latest software version to a USB
memory stick. Note: before transferring the “bin” file make sure the
memory stick does not contain other files or data.
Step 2:
Open the cover at the bottom and remove the battery and then
insert the U disk to the USB port. (See Fig. J1)
Step 3:
Insert the battery pack and press the ON/OFF button for ten seconds
until the mower is powered ON. The new software version will be
displayed in the bottom right corner of the display. (See Fig. J2)
Step 4: Remove the memory stick and refit the battery cover.
Step 5: After installing the new software you will need to reset the
diagnostic panel on your mower. Firstly, position the mower on a
horizontal surface.
Press Key “2” to enter the diagnosis interface, and press Key “5” for
a few seconds until the three numbers 1 2 & 3 highlighted belowturn
back to zero. (See Fig. J3)
7. Maintenance
Your Landroid
®
L needs to be checked from time to time. The
Landroid
®
L works hard and after time needs a good cleaning as
well as to have its parts replaced, as they can become worn. In
the following we want to let you know how to take care of your
Landroid
®
L.
7.1 Keep it Sharp
WARNING: Before cleaning, adjusting, or replacing
the Blades, turn your Landroid
®
L OFF by pressing
the ON/OFF Button to OFF and put on protective gloves.
WARNING! When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades . This is important to ensure
blade retention. Failure to use new screws could cause
serious injury.
The Landroid
®
L does not cut grass like other mowers. Its Blades
(17) are razor sharp on all 4 edges and spin in both directions
for maximum cutting capacity (See Fig. K).Each blade of your
Landroid
®
L has 4 cutting edges. Depending on the frequency
the Landroid
®
L mows your lawn, the cutting blades will need
to be flipped/rotated periodically for a new cutting edge. If your
Landroid
®
L is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
4
3
1
2
K
1
2
3
J1
J2
J3
