Worx Landroid WR130E, Installation Manual

11

EN

Charge your Landroid

®

 before the first operation

When connecting the power cord of the charging base to the 
adapter, align the notch on the power cord (b) with the groove on 
the adapter (a). 
Connect the adapter to the electrical outlet. The LED on the 
charging base will turn on in red color. Manually dock Landroid

®

into the charging base while Landroid

®

 is powered off. The green 

light on the charging base will turn green and Landroid

®

 will 

begin to charge. 
If the power cord is in Landroid

®

's working area, you may bury it 

if desired.

NOTE: 

If you want to plug the adapter in an indoor electrical 

outlet, you need to route the power cord through the hole in the 
wall.

Peg the boundary wire

Before pegging the boundary wire, it is recommended to use a 
normal lawn mower or a grass trimmer to cut the grass along 
the boundary. Then the wire should be laid as close as possible 
to the ground to prevent your Landroid

®

 accidentally cutting the 

wire. The boundary wire is powered with a very low voltage 
totally safe to humans and pets.
Pull out a length of boundary wire around 80cm and fasten it 
to the ground near the charging base. Later, this end of the 
boundary wire (IN-wire) will be connected to the BLACK terminal 
after pegging your boundry wire.

NOTE: 

The extended boundary wire should not exceed 400m or 

it may cause signal problem.

2

3

b

a

a

b

80cm

WR130E WR131E

WR141E WR144E

BLACK

RED