Worx NITRO WG749E, Manual

13

Cordless Lawn mower 

               EN

2. Motor stops 

while mowing.

A. Release Operating Bail to turn 

mower off. Remove safety key and 

batteries,turn mower over and check 

that blade is free to turn. If not free, 

return to an authorized servicer. 

Blade should turn freely.

B. Raise cutting height of wheels to 

highest position and start mower.

C. Has battery been fully charged? 

Plug in charger and wait for green 

light to come on.

D. Avoid overloading the mower. Slow 

down the cutting pace by pushing 

mower slower or raise the cut height. 

Or both.

3. Mower runs 

but cutting 

performance is 

unsatisfactory, 

or does not cut 

entire lawn.

A. Has battery been fully charged? Plug 

in charger and wait for green light to 

come on.”

B. Release Operating Bail to turn mower 

off. Remove safety key and batteries. 

Turn mower over and check: Blade for 

sharpness - Keep blade sharp. Deck and 

discharge chute for clogging.

C. Wheel height adjustment may be set 

too low for grass condition. Raise cutting 

height.

4. Mower is too 

hard to push.

A. Raise cutting height to reduce 

deck drag on grass. Check each 

wheel for free rotation.

5. Mower is 

abnormally 

noisy and 

vibrates.

A. Release Operating Bail to turn 

mower off. Remove safety key 

and batteries. Turn mower on 

side and check blade to ensure it 

has not been bent or damaged. If 

blade is damaged, replace with a 

replacement blade. If the underside 

of the deck is damaged return mower 

to an Authorized service center.

B. If there is no visible damage to the 

blade and the mower still vibrates: 

Release Operating Bail to turn mower 

off, Remove safety key and batteries, 

and remove blade. Rotate blade 180 

degrees and retighten. If mower 

still vibrates, return the mower to an 

authorized service center.

6. Battery 

charger LED’s 

not on.

A. Check plug connection.

B. Replace charger.

7. Battery 

charger LED 

does not flip to 

green.

A. Battery needs to be diagnosed. 

Take to authorized service center.

8. Mower not 

picking up 

clippings with 

the Grass 

Collection Bag.

A. Remove mulch plate when 

bagging.

B. Chute clogged. Release Operating 

Bail to turn mower off. Remove safety 

key and batteries. Clear chute of 

grass clippings.

C. Too much cut grass. Raise cutting 

height of wheels to shorten length 

of the cut.

D. Bag full. Empty bag more often.

9. When 

mulching there 

are clippings 

visible.

A. Too much cut grass. Raise cutting 

height of wheels to shorten length of 

the cut. Do not cut off more than 1/3 

of total length.

B. Check blade for sharpness. Always 

keep blade sharp.

10. Low or 

diminished run-

time after many 

uses

A. Return to Authorized Service 

location - may need new battery.

11. The battery 

charger LED 

flashes red and 

the battery can’t 

be charged.

A. The battery overheats after 

continuous use. Remove battery 

from the charger and allow it to cool 

to 42°C or less.

ENVIRONMENTAL 

PROTECTION

Disposal

The machine, its accessories and packaging 

materials should be sorted for environmentally friendly 

recycling. The plastic components are labeled for 

categorized recycling.