Worx Sonicrafter WX673 Original Instructions Manual Download

Page: 11 / 128

High frequency multi-function tool EN

of injury from the sharp edges of the
application tools. Application tools can
become very hot while working, presenting
danger of burns!

wARNING:

To reduce the risk of

injury, do not let the Universal end

cut blades or any segment saw blades

face back toward the user’s hand.

Unscrew the fastening piece (8).
Clean the tool holder, the application tool and
the fastening piece (8).
Place the application tool exactly onto
the hex-shaped tool holder. Note that the
application tool has a flush fit.
Reposition the fastening piece (8) using the
supplied allen key.

2. ADAPTER (21) (See Fig. B3)

Accessories of other brands (Fein

, Bosch

)

can be fitted onto the Sonicrafter

brand tool

using the adapter.

NOTE:

Fein is a registered trademark of

C. & E. Fein GmbH. Bosch is a registered
trademark of Robert Bosch GmbH.
1) Use the allen key (23) to unscrew the

fastening piece (8) and then remove it
from the tool holder.

2) Clean the tool holder, the adapter the

application tool and the fastening piece.

3) Fit the adapter onto the tool holder,

then place the application tool onto the
adapter. Make sure that the tool holder,
the adaptor, and the application tool share
a flush fit.

4) Reposition the fastening piece onto the

application tool and tighten with the allen key.

NOTE:

Make sure the adapter matches the

application tool. The adapter (I) is matched to
the application tool of Fein

. The adapter (II)

is matched to the application tool of Bosch

(See Fig. B3)

3. MOUNTING/cHANGING THE

SANDING SHEET (See Fig. c)

Align the sanding sheet and press it onto the
sanding pad by hand.
Firmly press the power tool with the sanding
sheet against a flat surface and briefly switch
the power tool on. This provides for good
adhesion and prevents premature wear.

If one point has become worn, pull off the
sanding sheet, turn it 120° and place it on
again.

4. OPERATING THE ON/OFF SwITcH

To start the machine, push the On/Off switch
(2) forward so that the “I” is indicated on the
switch.
To switch off the machine, push the On/Off
switch (2) toward the rear so that the “0” is
indicated on the switch.

5. USING THE VARIABLE SPEED

cONTROL

Select oscillation frequency (speed) while
the motor is running.
The variable speed control (5) can be used
to set the optimum oscillating frequency
according to the accessories used and the
respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing
stone and metal.
Low oscillation frequency:
Polishing varnishes.

6. MOUNTING THE SUcTION DEVIcE

(See Fig. D1, D2)

When vacuuming, mount the suction device
as shown in D1-D2.

NOTE:

Using the sanding pad perforated.

You can only do the vacuuming after fitting
the dust collector.

7. SANDING

Typical application: Wood, metal; small
areas, especially corners, edges and places
difficult to access.
Select high oscillation frequency.
Sand with a constant movement and light
pressure.
Heavy pressure does not increase the removal
– the sanding sheet merely wears faster.

8. SAwING wITH THE SEGMENT SAw

BLADE

Typical application: Wood, plastics, sheet metal.
Select high oscillation frequency.
The saw blade lasts longer if the wear
is distributed evenly. To ensure an even