Worx Sonicrafter WX673 Original Instructions Manual Download

Page: 12 / 128

High frequency multi-function tool EN

distribution, loosen the saw blade, rotate it
and retighten firmly.

9. SAwING wITH THE UNIVERSAL END

cUT SAw BLADE (See Fig. E)

wARNING: The sawing teeth are

very sharp. Do not touch during

mounting and application.

The workpiece must be inserted firmly or
clamped tightly before it is cut.
Typical application: Wood, metal (e. g.
nails),plaster board and soft plastics.
When plunging and sawing use a slight pendulum
motion, to allow sufficient chip removal.

10. ScRAPING

Typical application: Scraping off old varnish
or adhesives, removing glued carpeting, e.
g. on stairs or other small to medium-sized
surfaces.
Select medium/high oscillation frequency
(for variable speed models).

11. LED LIGHT (1)

To turn on the light simply press the on/off
switch. When you release the on/off switch,
the light will be off.
LED lighting increases visibility-great for
dark or enclosed area. LED is also a battery
capacity indicator. It will flash when power
gets low.

12. TEMPERATURE DEPENDENT

OVERLOAD PROTEcTION

When using as intended for, the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 75°C is exceeded, the
electronic control switches off the power
tool until the temperature is in the optimum
temperature range again.

13. PROTEcTION AGAINST DEEP

DIScHARGING

The Li-ion battery is protected against deep
discharging by the “Discharging Protection
System”. When the battery is empty, the
machine is switched off by means of a
protective circuit: The inserted tool no longer
rotates.

14. DISPOSAL OF AN ExHAUSTED

BATTERy PAcK

To preserve natural resources, please
recycle or dispose of the battery
pack properly. This battery pack

contains Lithium batteries. Consult your local
waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating
your tool, then remove the battery pack
from the tool housing and cover the battery
pack connections with heavy-duty adhesive
tape to prevent short circuit and energy
discharge. Do not attempt to open or remove
any of the components.

WORKING HINTS FOR YOUR

TOOL

If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always keep the
blade sharp.
Always ensure the workpiece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the cutting or sanding finish.
Start your tool before working and turn it off
only after you stop working.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sandpaper to wear away, it
will damage the sanding pad. The guarantee
does not cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for finishing surfaces. If necessary, first make
a test run on scrap material.
Excessive force will reduce the working
efficiency and cause motor overload.
Replacing the accessory regularly will
maintain optimum working efficiency.