Worx Sonicrafter WX693, Safety And Operating Manual

Sonicrafter                WX693 WX693.9

10

We recommend that you purchase your accessories 

listed in the above list from the same store that sold 

you the tool. Refer to the accessory packaging for 

further details. Store personnel can assist you and 

offer advice.

NOTE:

 When plunging and sawing use a 

slight pendulum motion, to allow sufficient 

chip removal.

The saw blade lasts longer if the wear is distributed 

evenly. To ensure an even distribution, loosen the 

saw blade, rotate it and retighten firmly.

Cut/Sand with a constant movement and light pres-

sure.

Heavy pressure does not increase the cut/removal 
rate – the accessory merely wears faster.

WORKING HINTS FOR YOUR 

TOOL

If your power tool becomes too hot, espe-
cially when used at low speed, set the speed 
to maximum and run it with no load for 2-3 
minutes to cool the motor. Avoid prolonged 
usage at very low speeds. Always keep the 
blade sharp.
Always ensure the workpiece is firmly held or 
clamped to prevent movement.
Any movement of the material may affect the 
quality of the cutting or sanding finish.
Start your tool before working and turn it off 
only after you stop working. 
Do not start sanding without having the sand-
paper fitted.
Do not allow the sandpaper to wear away , it 
will damage the sanding pad. The guarantee 
does not cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces, 
medium grit for smooth surfaces and fine grit 
for finishing surfaces. If necessary, first make 
a test run on scrap material.
Excessive force will reduce the working ef-
ficiency and cause motor overload. Replacing 
the accessory regularly will maintain optimum 
working efficiency.

MAINTAIN TOOLS WITH 

CARE

Your power tool requires no additional 
lubrication or maintenance.  There are no 
user serviceable parts in your power tool. 
Never use water or chemical cleaners to clean 
your power tool. Wipe clean with a dry cloth. 
Always store your power tool in a dry place. 
Keep the motor ventilation slots clean. Keep 
all working controls free of dust.
The ambient temperature range for tool and 
battery use and storage is 0

°C

-45

°C

.

The recommended ambient temperature 
range for the charging system during charging 
is 

0

℃

-

40

℃

.