Worx Sonicrafter WX693, Safety And Operating Manual

Sonicrafter                WX693 WX693.9

8

1.  HYPERLOCK™ ACCESSORY CLAMPING 

LEVER

2.  ON/OFF SWITCH

3.   VARIABLE SPEED DIAL

4.   VENTING SLOTS

5.   UNIVERSAL-FIT ACCESSORY INTERFACE*

6.   SMALLER FLANGE (FOR OTHER BRANDS’ 

SANDING PADS)

7.   FLANGE

*Works with other oscillating tool brands’ 

accessories. 

The following compatible brands are trademarks 

owned by third parties which may be registered by 

their respective owners: Black & Decker

®

, Bosch

®

, 

Chicago Electric

®

, Craftsman

®

, Dremel

®

, Fein

®

, Gen-

esis

®

, Makita

®

, Mastercraft

®

, Milwaukee

®

, Performax

®

, 

Porter Cable

®

, Ridgid

®

, Ryobi

®

, Skil

®

, and Tool Shop

®

.

Not all the accessories illustrated or 

described are included in standard delivery.

TECHNICAL DATA

Type 

    WX693 WX693.9 (6-designation of 

machinery, representative of high frequency 

oscillation tool)

WX693 

WX693.9

Voltage

20V    Max**

Oscillations speed

8000-18000 /min

Oscillation angle

4°

Battery capacity

2.0Ah

Charging time

1hr

/

Machine weight 

1.4 KG

1 KG

Charger 

1

(WA3860)

/

Battery pack

1

(WA3551.1)

/

**

Voltage measured without workload. Initial battery 

voltage reaches maximum of 20 volts. Nominal volt-

age is 18 volts

OPERATING INSTRUCTIONS

 NOTE: 

Before using the tool, read the 

instruction book carefully.

INTENDED USE

The power tool is intended for sawing and 
remodeling wooden materials, plastic, plaster, 
non-ferrous metals and fasteners (e.g. nails 
and clamps) as well as for working on soft wall 
tiles and for dry grinding of small surfaces. It is 
especially suitable for working close to edges 
and for flush cutting

ASSEMBLY AND OPERATION

ACTION

FIGURE

Mounting Accessories

See Fig. A-C

Mounting The Sanding Sheet

See Fig. D

Operating The On/Off Switch

See Fig. E

Using The Variable Speed Dial

See Fig. F

Remove Or Install Battery Pack

See Fig. G

LED Light

See Fig. H

The Variable Speed Dial can be used to set 
the optimum oscillating frequency according 
to the accessories used and the respective 
application.

Oscillation frequency

Application

High oscillation 
frequency:

Sanding, sawing, rasping 
and polishing stone and 
metal.

Low oscillation 
frequency:

Scraping, polishing 
varnishes.