10
2-in-1 Grass Trimmer/Edger
WG118E
A ‘clattering’ noise will be heard for a short time. This
is normal and is caused by the line being cut by the
line cutter. Once the line is cut to the correct length, the
‘clattering’ noise will stop and the trimmer motor will
run at full speed.
To feed more line, stop the trimmer completely, then
restart, allowing the motor to reach full speed. Repeat
this until you hear the ‘clattering’ noise of the line
cutting. (Do not repeat this procedure more than 6
times).
11. MANUAlly fEEdING THE lINE (See fig. J)
Press and release the Line Feed Button (16) (See Fig. J)
whilst gently pulling out on one of the lines until it has
reached the line cutter.
When the required amount of line is fed out, gently pull
on the second line (there is no need to press the Line
Feed Button again). If the line extends past the line
cutter, too much line has been fed out.
If too much line is fed out, remove the spool cap and
click the spool counter-clockwise until the line is at the
desired length.
12. REMOVING THE CAP
Press and hold in the two Cap Release Latches (12) (See
Fig K).
Pull the Cutting Head Cover (11) away from the Cutting
Head (14). Keep the Cutting Head Cover and the inside
of the Cutting Head clean from debris. To replace the
Cutting Head Cover, press it firmly onto the spool
holder. Ensure that it is correctly connected by trying
to remove it without depressing the two Cap Release
Latches.
13. CHANGING THE lINE SPOOl
First take off the Cutting Head Cover (11) and remove
the old Spool (13). Place the new Spool onto the
Cutting Head (14). Feed one line through the Eyelet
(15), and then repeat for the second line. Reattach the
Cutting Head Cover.
WARNING!
our Trimmer is designed to only
use line with a maximum diameter of 0.065
(1.65mm”. Only use nylon line.
IMPORTANT - Always wind the line onto the
upper section of the spool first.
14. TO MANUAlly WINd lINE
Take approximately 5m of line and insert 15mm of line
into one of the holes in the upper section of the Spool
(13) (See Fig L1). Wind the line in the direction of the
arrows on the top of the Spool. Repeat process with
b
a
A
B
C
D
E1
E2
F
G
H1
16
H2
I
J
15
11
12
13
14
K
L1
L2
L3
L4
RIGHT
WRONG
b
a
A
B
C
D
E1
E2
F
G
H1
16
H2
I
J
15
11
12
13
14
K
L1
L2
L3
L4
RIGHT
WRONG
