13
3 in 1 Grass Trimmer/Edger
WG160E.5
If the noise of the line being cut can’t be heard, more
line will need to be fed out.
To feed more line, it is first necessary to allow the
trimmer to stop completely; it must come to a complete
rest, then restart, allowing the motor to reach full
speed.
Repeat above until you hear the line hitting against the
Line Cutter.
To MANUAlly feeD THe lINe
(See fig. k1)
Turn off the trimmer and remove the battery.
If required, line can be fed out manually.
To operate, press and release manual Line Feed Button
(17), while gently pulling out the line until it is long
enough to reach the Line Cutter.
If the line extends past the Line Cutter, too much line
has been fed out.
If too much line is fed out, remove the Spool Cap and
turn Spool counter-clockwise until the line is at the
desired length.
To ReMove THe SPool cAP coveR (See fig.
k2)
Press and hold in the two Cap Release Latches (19) (See
Fig. K2).
Pull the Spool Cap Cover (18) away from the Cutting
head (21). Keep the Spool Cap Cover and the inside
of the Cutting head clean from debris. To replace the
Spool Cap Cover, press it firmly onto the Spool holder.
Ensure that it is correctly connected by trying to remove
it without depressing the two Cap Release Latches.
RePlAce THe TRIMMeR lINe AND SPool (See
fig. k3).
Turn off the trimmer and remove the battery.
Remove Spool Cap Cover.
Remove the old Spool from Spool holder. Clear any
broken line or cutting debris from the spool area. Pull
the line from the new replacement Spool through the
eyelet of the Spool holder. Place new Spool into the
holder with the
cut out areas of the Spool facing
inward or down. When installed into the Spool
Holder, the smooth side of the Spool should be
visible.
Release line from cleat on the Spool.
Refit the Spool Cap Cover.
22
18
19
20
21
17
RIGHT
WRONG
H3
I1
I2
J1
J2
K1
K2
K3
L1
L2
L3
L4
