Worx WG184, Manual

13

EN

2-in-1 Cordless Grass 

Trimmer/Edger 

OPERATION INSTRUCTIONS

WARNING! 

The charger and battery pack are 

specially designed to work together so do not 

attempt to use any other devices. Never insert or 
allow metallic objects into your charger or battery 
pack connections because of an electrical failure and 
hazard will occur.

1. COMMAND FEEDING THE LINE 
(See Fig. J)

Your trimmer is equipped with a Command Feed 
System. For efficiently feeding the line, just press the 
command feed button while the machine is running 
until you hear the ‘clattering’ noise of the line cutting.
The motor will shut off when pressing the Command 
Feed button and will restart when releasing the 
button. During that process the line will automatically 
feed additional line for cutting.

2. MANUALLY FEEDING THE LINE 
(See Fig. K)

Turn off the trimmer and remove the battery. If 
required, line can be fed out manually. To operate, 
press and release manual Line Feed Button, while 
gently pulling out the line until it is long enough 
to reach the Line Cutter. If the line extends past the 
Line Cutter, too much line has been fed out. If too 
much line is fed out, remove the Spool Cap and turn 
Spool counter-clockwise until the line is at the desired 
length. 

3. MANUALLY WINDING THE LINE 
(See Fig. O, P, Q, R)

Take approximately 20ft (6m) of line. Insert 0.080 
inches (2mm )of line into the Spool holes and wind 
line in the direction of the arrows on the top of the 
Spool. Leave approximately 4 inches (100mm) of line 
unwound and place into the cleat. Ensure that the 
line is neatly coiled on the Spool. Failure to do so will 
impair the efficiency of the automatic line feed. Then 
fit the Spool as described above in “Replacing the 
trimmer line and Spool”

STORING YOUR GRASS 

TRIMMER

Always remove the battery pack from 
your trimmer after use.

To store your grass trimmer

The trimmer is provided with a hanging slot for 
storing the trimmer on the wall. (See Fig. S)
Store in a dry place where the trimmer and battery 
can be protected from damage.

MAINTENANCE

Always remove the battery pack from 
your trimmer after use.

Always check the product prior to being used 
for any damage.

After use, disconnect the battery from the tool and 
check for damage. 
Your power tool requires no additional lubrication 
or maintenance. There are no user serviceable parts 
in your power tool. Never use water or chemical 
cleaners to clean your power tool. Wipe clean 
with a dry cloth. Always store your power tool in 
a dry room temperature location. Keep the motor 
ventilation slots clean. Keep all working controls 
free of dust. 

For Battery tools

The ambient temperature range for the use and 
storage of tool and battery is 0

ȭ

-45

ȭ

.

The recommended ambient temperature range for 
the charging system during charging is 0

ȭ

-40

ȭ

.