Worx WG202 Instructions Manual Download

Page: 10 / 28

Hedge Trimmer

ENG

cutting blade.
Wipe the surface with a dry cloth.

Warning:

Never use water for cleaning your

trimmer. Do not clean with chemicals, including
gasoline, or solvents as this can damage your
trimmer.

LUBRICATING THE CUTTING BLADE

For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure your trimmer is
disconnected from the power supply. Apply oil
between the two blades (See Fig K).
Your trimmer should be stopped, disconnected
and oiled occasionally during use.

AT THE END OF THE CUTTING SEASON

Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.

TO STORE YOUR HEDGE TRIMMER

The  trimmer  blade  cover  holder  is  provided
with  2  hanging  slots  for  storing  the  trimmer
on the wall. (See Fig L) Ensure the blade cover
holder  is  ﬁtted  before  storage.  Store  in  a  dry
place  where  your  trimmer  can  be  protected
from damage.

WARRANTY STATEMENT

30 DAY Satisfaction Guarantee
If for any reason you are dissatisﬁed with any
WORX product, you can return the product,
along with proof of purchase, within 30 days
for a full refund.

If your WORX product becomes defective due
to faulty materials or workmanship within the
speciﬁed warranty period of;

• 24 months for DIY and light trade use, from
the date of purchase.

We guarantee to repair or replace all defective
parts free of charge, repair products subject

before entering the material to be cut.
Always  work  going  away  from  people  and
solid objects such as walls, large stones, trees,
vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer.  Disconnect  the  hedge  trimmer  from
the power supply and clear the jammed debris
from the cutting blades.
Wear  gloves  when  trimming  thorny  or  prickly
growth.
Move the hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to feed
into the cutting blade.
Allow  the  cutting  blades  to  reach  full  speed
before  cutting.    When  operating,  keep  the
cutting  blades  away  from  people  and  objects
such as walls, large stones, trees, vehicles, etc.
If  the  blade  stalls,  immediately  stop  the
trimmer.  Disconnect  from  the  power  supply
before attempting to clear jammed debris from
the cutting blades.

TOP CUTTING

Use  a  wide  sweeping  motion  (See  Fig  I).  A
slight  downward  tilt  of  the  cutting  blades  in
the  direction  of  motion  gives  the  best  cutting
results.

SIDE CUTTING

When trimming the sides of the hedge, begin
at the bottom and cut upwards (See Fig J),
tapering the hedge inward at the top. This
shape will expose more of the hedge, resulting
in a more uniformed growth.

Warning: Check the extension cord

before using. If damaged, replace

immediately. Never use your tool with

a damaged cord, as this could cause

electrical shock and result in serious

injury.

If the supply cord is damaged, it should be

replaced by an approved service center.

Do not expose tool to rain.

MAINTENANCE

CLEANING

Disconnect from power supply. Using a soft
brush to remove debris from all air intakes and