Worx WG212E, Safety And Operating Manual

9

8

Hedge Trimmer 

WG212E

4. StARtING AND StoPPING (See fig e, f)

BefoRe StARtING yoUR HeDGe tRIMMeR

Remove Blade Sheath (7).

to StARt yoUR HeDGe tRIMMeR

There are two switch levers fitted in your Hedge 
trimmer (2&3).
Both switch levers need to be depressed for the product 
to 

StARt

. Depress and hold the Front Switch Lever (3) 

and depress the Rear Switch Lever (2). (See Fig. E)

to StoP yoUR HeDGe tRIMMeR

Move Hedge trimmer away from cutting area before 
stopping.
To 

StoP

, release one of the switch levers. (See Fig. F)

WARNING:

 If any parts are missing, damaged or 

broken, do not operate your Hedge trimmer until 

all damaged parts have been replaced or repaired. 
Failure to do so could result in serious personal injury. 
DO NOT USE WITHOUT HANDLE AND GUARD

5. HoW to USe yoUR HeDGe tRIMMeR

Inspect the area to be cut before each use, remove 
objects which can be thrown or become entangled in 
the cutting blades. 
Always hold the Hedge trimmer with both hands and 
with the blade away from you before turning it on. 

Always keep the power cord behind the Hedge 

trimmer when in use. Do not place it over the 

hedge that you are trimming where it may be cut 

by the blade.

When trimming new growth, use a wide sweeping 
action so that the stems are fed directly into the blade.
Allow the cutting blades to reach full speed before 
entering the material to be cut.
Always work going away from people and solid objects 
such as walls, large stones, trees, vehicles etc.
If the blade stalls, immediately stop the Hedge trimmer. 
Disconnect the Hedge trimmer from the mains and clear 
the jammed debris from the cutting blades. 
Wear gloves when trimming thorny or prickly growth.
Move the Hedge trimmer to feed the branches directly 
into the blade cutting edges.
Do not try to cut stems that are too large to feed into the 
cutting blade.

toP cUttING (See G)

Use a wide sweeping motion. A slight downward tilt of 
the cutting blades in the direction of motion gives the 
best cutting results.

SIDe cUttING (See H)

When trimming the sides of the hedge, begin at the 
bottom and cut upwards, tapering the hedge inward 

A

B

C

D

E

F

G

H

I