10
Electric Hedge Trimmer
WG216E WG216E.X
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4. INTENDED USE
This machine is intended to be used domestically for
cutting and trimming hedges and bushes.
5. OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
WARNING!
Do not use the product without
attaching the guard and front handle.
ACTION
FIGURE
Preparation
CABLE STRAIN RELIEF
See Fig. A
OPERATION
REMOVING THE BLADE SHEATH
See Fig. B
STARTING AND STOPPING
WARNING:
If any parts are
missing, damaged or broken, do
not operate your Hedge trimmer until
all damaged parts have been replaced
or repaired. Failure to do so could
result in serious personal injury. DO
NOT USE WITHOUT HANDLE AND
GUARD
TO START YOUR HEDGE TRIMMER
Depress the safety switch on front
handle with one hand and the on/off
switch on the rear handle with
the other hand to turn on the hedge
trimmer. The trimmer will stay on as
long as the two switches are
depressed.
See Fig. C
TO STOP YOUR HEDGE TRIMMER
Move Hedge trimmer away from cut-
ting area before stopping.
To stop, release either on/off switch or
safety switch
See Fig. D
USING YOUR HEDGE TRIMMER
WARNING:
Check extension
cords before each use. If
damaged replace immediately. Never
use your tool with a damaged cord
since touching the damaged area could
cause electrical shock resulting in
serious injury.
If the supply cord is damaged, it should
be replaced by a local approved Service
Centre.
Do not try to cut stems that are too
large to feed into the cutting blade.
Take care not to expose this tool to rain.
TOP CUTTING
See Fig. E
SIDE CUTTING
See Fig. F
LUBRICATING THE CUTTING BLADE
For easier operation and longer life,
lubricate the cutting blades before and
after each use. Before
lubricating, make sure your Hedge
trimmer is disconnected from electrical
outlet.
See Fig. G
HOW TO USE YOUR HEDGE
TRIMMER
Inspect the area to be cut before each use, remove
objects which can be thrown or become entangled in
the cutting blades.
Always hold the Hedge trimmer with both hands and
with the blade away from you before turning it on.
Always keep the power cord behind the Hedge
trimmer when in use. Do not place it over the
hedge that you are trimming where it may be cut
by the blade.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the blade.
(See Fig. E & F))
Allow the cutting blades to reach full speed before
entering the material to be cut.
Always work going away from people and solid objects
such as walls, large stones, trees, vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer. Disconnect the Hedge trimmer from the
mains and clear the jammed debris from the cutting
blades.
Wear gloves when trimming thorny or prickly growth.
Move the Hedge trimmer to feed the branches directly
into the blade cutting edges.
Do not try to cut stems that are too large to feed into
the cutting blade.
TOP CUTTING (SEE Fig. E)
Summary of Contents for WG216E
