13
12
3-in-1 Lawn mower
en
13
12
Side-diScharge chute (See g1 & g2)
Using the mulching insert and side-discharge
chute, the grass can be discharged from the
side-discharge of the machine.
1. Raise the side-discharge cover and hold it
up,
2. Position the side-discharge chute onto the
hooks, and then release the cover to lock
the side-discharge into position.
reMoving/eMptying
unplug tool, and wait for blade to
coMe to a coMplete Stop
1. Lift the safety flap and hold it up. The grass
collection bag will drop automatically.
adjuSting the cutting height (See
h)
warning:
STOP REALEASE THE
SWITH LEvER, UNPLUG TOOL, AND
WAIT FOR BLADE TO COME TO A COMPLETE
STOP The blades continue to rotate after the
machine is switched off, a rotating blade can
cause injury.
caution:
Do not touch rotating blades.
The lawnmower can be set to 6 cutting heights
between 1.5” and 3.5”.
1. Your mower features the Worx one touch
cut height adjustment
2. Move the cutting height adjustment lever
outwards then adjust to the preferred
position.
3. This system will adjust all four wheels at
the same time, up or down.
OPeRATIOn
Starting (See e)
DO NOT connect the extension cord to power
source until you have finished reading this
manual and you are ready to start mowing.
1. The extension cord must be polarized and
will only plug in one way, orient the wide
slot with the wide blade into the pigtail.
Connect the plug to the mains and switch
ON.
a. the switchbox is provided with a
lock-off button to prevent accidental
starting.
2. With one hand press and hold the safety
button
1
, with the other hand squeeze
the switch lever
2
towards the handle,
and release the safety lock off button.
The machine is now started; wait until the
product is at full speed before cutting the
grass. Then use both your hands to hold
the switch lever to keep it running.
Stopping (See e)
1. Release the switch lever
2
. The lever is
spring loaded and will quickly return to the
off position upon release.
reMoving Mulch inSert (See f)
To remove the mulching insert so that you
can bag the grass or side discharge follow the
steps listed below:
1.
unplug tool, and wait for blade
to coMe to a coMplete Stop
2. Raise the safety guard and hold it up.
3. Grasp the middle of the insert, lift and pull
out the mulching insert completely.
4. The safety guard is spring loaded. When
you release it, the guard will return to the
closed position.
inStalling Mulch inSert (See f)
1.
unplug tool, and wait for blade
to coMe to a coMplete Stop
2. Raise the safety guard and hold it up.
3. Slide the mulching insert (10) into the
discharge opening until it is firmly in
contact with the deck.
4. Release safety guard and ensure it is
properly closed.
