Cordless Lawn Mower
EN
10
be tilted for transportation when crossing
surfaces other than grass, and when
transporting the lawnmower to and from
the area to be mowed.
j) Never operate the lawnmower with
defective guards, or without safety devices,
for example deflectors and/or grass
catchers, in place.
k) Switch on the motor carefully according to
instructions and with feet well away from
the blade(s).
l) Do not tilt the lawnmower when switching
on the motor, except if the lawnmower has
to be tilted for starting. In this case, do not
tilt it more than absolutely necessary and
lift only the part which is away from the
operator.
m) Do not start the machine when standing in
front of the discharge.
n) Do not put hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all times.
o) Do not transport the lawnmower while the
power source is running.
p) Stop the machine and disconnect the plug
from the mains. Make sure that all moving
parts have come to complete stop.
- whenever you leave the machine;
- before clearing blockages or unclogging
chute;
- before checking, cleaning or working on the
lawnmower;
- after striking a foreign object. Inspect
the lawnmower for damage and make
repairs before restarting and operating the
lawnmower.
if the lawnmower starts to vibrate abnormally
(check immediately)
- inspect for damage;
- replace or repair any damaged parts;
- check for and tighten any loose parts.
MAINTENANCE AND STORAGE
a) Keep all nuts, bolts and screws tight to be
sure the machine is in safe working
condition;
b) Check the grass catcher frequently for wear
or deterioration;
c) Replace worn or damaged parts for safety.
Use only genuine replacement parts and
accessories.
d) Be careful during adjustment of the
machine to prevent entrapment of the
fingers between moving blades and fixed
parts of the machine.
e) On machines with multi blade, take care as
rotating one blade can cause other blades
to rotate.
f) Always allow the machine to cool down
before storing.
g) When servicing the blades be aware that,
even though the power source is switched
off, the blades can still be moved.
RECOMMENDATION
To connect the machine only to a supply
circuit protected by a residual current device
(RCD ) with a tripping current of not more than
30 mA.
SYMBOLS
Read instruction handbook
before operation this
machine.
Keep bystanders away.
Beware of sharp blades.
Blades continue to rotate
after the motor is switched
off- Remove plug from
mains before maintenance
or if cord is damaged.
Keep the supply flexible cord
away from the blades.
