Worx WG743E, Safety And Operating Manual

18

WG743E WG743E.X  Cordless Lawn mower

Clean the exterior of the machine thoroughly using 
a soft brush and cloth. Do not use water, solvents or 
polishes. Remove all grass and debris, especially from 
the ventilation slots.
Turn the machine on its side and clean the blade area. 
If grass cuttings are compacted in the blade area, 
remove with a wooden or plastic implement.
Store the machine in a dry place. Do not place other 

objects on top of the machine.
To aid storage, release the Lock Cam Lever, and fold the 
upper handle as shown in Fig.K1, K2.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. 
Check with your local authorities or retailer for recycling advice.

TROUBLE SHOOTING

Problem

Solution

1. Mower doesn’t run when 
bail handle is activated.

A. Check to make sure safety key has been installed and is fully seated and 
that button on switch housing is being completely pushed.
B. Release bail handle to turn mower off. Remove safety key, turn mower 
over and check that blade is free to turn. If not free, return to an authorized 
servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light to 
come on.

2. Motor stops while mowing.

A. Release bail handle to turn mower off. Remove safety key, turn mower over and 
check that blade is free to turn. If not free, return to an authorized servicer. Blade 
should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light to 
come on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing mower 
slower or raise the cut height. Or both.

3. Mower runs but 
cutting performance is 
unsatisfactory, or does not 
cut entire lawn.

A. Has battery been fully charged? Plug in charger and wait for green light to 
come on.
B. Release bail handle to turn mower off. Remove safety key. Turn mower 
over and check: Blade for sharpness - Keep blade sharp. Deck and discharge 
chute for clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise 
cutting height.

4. Mower is too hard to push.

A. Raise cutting height to reduce deck drag on grass. Check each wheel for 
free rotation.

5. Mower is abnormally noisy 
and vibrates.

A. Release bail handle to turn mower off. Remove safety key. Turn mower on 
side and check blade to ensure it has not been bent or damaged. If blade is 
damaged, replace with a replacement blade. If the underside of the deck is 
damaged return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates: 
Release bail handle to turn mower off, remove safety key and remove blade. 
Rotate blade 180 degrees and retighten. If mower still vibrates, return the 
mower to an authorized service center.

6. Battery charger LED’s not 
on.

A. Check plug connection.
B. Replace charger.