19
18
19
18
3-in-1 Cordless Lawn Mower
EN
TROUBLE SHOOTING
ProBLEM
SoLUTioN
1. Mower doesn’t run when switch
lever is activated.
A. Check to make sure safety key has been installed
and is fully seated and that button on switch housing
is being completely pushed.
B. Release switch lever to turn mower off. Remove
safety key, turn mower over and check that blade
is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger
and wait for green light to come on.
2. Motor stops while mowing.
A. Release switch lever to turn mower off. Remove
safety key, turn mower over and check that blade
is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position
and start mower.
C. Has battery been fully charged? Plug in charger
and wait for green light to come on.
D. Avoid overloading the mower. Slow down the
cutting pace by pushing mower slower or raise the
cut height. Or both.
3. Mower runs but cutting
performance is unsatisfactory, or
does not cut entire lawn.
A. Has battery been fully charged? Plug in charger
and wait for green light to come on.”
B. Release switch lever to turn mower off. Remove
safety key. Turn mower over and check: Blade for
sharpness - Keep blade sharp. Deck and discharge
chute for clogging.
C. Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
4. Mower is too hard to push.
A. Raise cutting height to reduce deck drag on grass.
Check each wheel for free rotation.
5. Mower is abnormally noisy and
vibrates.
A. Release switch lever to turn mower off. Remove
safety key. Turn mower on side and check blade to
ensure it has not been bent or damaged. If blade is
damaged, replace with a replacement blade. If the
underside of the deck is damaged return mower to a
Authorized service center.
B. If there is no visible damage to the blade and the
mower still vibrates: Release switch lever to turn
mower off, remove safety key and remove blade.
Rotate blade 180 degrees and retighten. If mower still
vibrates, return the mower to an authorized service
center.
6. Battery charger LED’s not on.
A. Check plug connection.
B. Replace charger.
Summary of Contents for WG787
