12AMP 2-in-1 Lawn Edger/Trencher EN
8
12) Don’t grasp the exposed cutting
blades or cutting edges when
picking up or holding the appliance.
13) Don’t Force Appliance
- It will do the
job better and with less likelihood of a
risk of injury at the rate for which it was
designed.
14) Don’t Overreach
- Keep proper footing
and balance at all times.
15) Stay Alert
- Watch what you are doing.
Use common sense. Do not operate
appliance when you are tired.
16) Disconnect Appliance
- Disconnect
the appliance from the power supply
when not in use, before servicing, when
changing accessories such as blades,
and the like.
17) Store Idle Appliances Indoors
- When
not in use, appliances should be stored
indoors in dry, and high or locked-up
place - out of reach of children.
18) Maintain Appliance With Care
-
Keep cutting edge sharp and clean for
best performance and to reduce the
risk of injury. Follow instructions for
lubricating and changing accessories.
Inspect appliance cord periodically,
and if damaged, have it repaired by
an authorized service facility. Inspect
extension cords periodically and replace
if damaged. Keep handles dry, clean, and
free from oil and grease.
19) Check Damaged Parts
- Before further
use of the appliance, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function. Check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
condition that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service center unless
indicated elsewhere in this manual.
SAVE THESE INSTRUCTIONS
Table 1
Minimum gauge for extension cords
Volts
Total length of cord in feet
120V
25
50
100
150
240V
50
100
200
300
Ampere rating
more than not
more than
AWG
0-6
18
16
16
14
6-10
18
16
14
12
10-12
16
16
14
12
12-16
14
12
Not
recommended
NOTE:
Only the applicable parts of the Table
need to be included. For instance, a 120-volt
product need not include the
240-volt heading.
Figure 1
Method of securing extension cord
CORD
SET
APPLIANCE CORD
(A) TIE CORD AS
SHOWN
(B) CONNECT PLUG
AND RECEPTACLE
FOR ALL DOUBLE-INSULATED
APPLIANCES
1) Replacement Parts
When servicing use only identical
replacement parts.
2) Polarized Appliance Connections
To reduce the risk of electric shock, this
appliance has a polarized plug (one
Summary of Contents for WG896
