16
EN
OPERATION MESSAGES
MESSAGE
LANDROID ACTION
Cutting grass
Cutting grass according to the mowing schedule.
Raining
The rain sensor detects water. Landroid will return to the charging station and stay
there until the sensor is completely dry. When the sensor is completely dry,
Landroid will automatically begin the rain delay countdown and then return to mow.
If you want Landroid to mow before the rain delay counter is finished, simply turn it
off then on again. Or you can remove the rain delay completely by setting the rain
delay time to zero.
Going home
Needs to recharge—while traveling back to the charge station, the cutting blade
does not operate in order to save energy.
Charging
‘Charging’ and charge percentage are displayed.
No working time scheduled
Stand-by, needs to be programmed as desired.
Not working today
Stand-by, will start according to mowing schedule.
Work done today
Zone searching
Landroid is searching a certain area to mow based on the customized work zone
parameters.
Charge complete
Landroid has completed its charging.
Emergency charge
Landroid is charging in a powered-off state.
ERROR MESSAGES
Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in doubt,
please visit our website at www.worx.com/landroid-support, where you will find useful videos and further support.
MESSAGE
CAUSE
ACTION
Outside working area!
Press START to reset.
Landroid cannot find
the boundary wire
signal.
1. If Landroid is actually outside of its working area: power off the mower, take
Landroid inside the working area, power on and press start.
2. If the associated error is displayed and the mower is inside the boundary
AND the charging station LED is green, then the wires leading into the
charging station are most likely reversed, and need to be switched.
WRONG PIN! Please
retry.
PIN code is wrong.
Input the correct PIN or re-set your PIN.
Blade motor fault!
Press START to reset.
Blade disc is blocked
by an object, e.g. a
branch.
Turn power off and remove battery.
Turn Landroid upside down and check if there’s anything preventing the blade
disc from rotating and remove any obstruction.
Turn the mower upright, and power on.
Blade is over-loaded by
thick dense grass.
Turn power off.
Take Landroid to an area with short grass or adjust the cutting height to a
higher setting.
Power on.
