17
EN
MESSAGE
CAUSE
ACTION
Wheels motor fault!
Press START to reset.
Rear wheel is blocked
in some way.
Turn power off and take Landroid to an area free from obstacles.
Turn power on.
If the error message is still displayed, turn power off. Turn Landroid
upside-down and check if there’s anything preventing the wheels from
rotating.
Remove any obstruction, if necessary, then turn the mower upright, and
power on.
Upside down! Press
START to reset.
This could have
happened when
Landroid came into
contact with a
sloping surface which
made it overturn.
Turn Landroid upright and remove any obstruction that might have caused
Landroid to overturn.
Mower stuck! Press
START to reset.
Landroid is stuck.
Also, if the rear wheels
cannot move and have
tried to course correct
several times in a short
period, or the bump
sensor has been
activated several times
in a short period, this
will cause a Stuck error.
Turn power off.
Take Landroid to an area of your lawn free of obstacles, then turn power on.
If the error message is still displayed: turn power off, turn Landroid
upside-down. Check if there is anything preventing the wheels from rotating.
Remove any obstruction, turn the Landroid upright, turn power on.
Mower lifted! Press
START to reset.
Landroid is lifted up.
Also, if the lift sensor
has been activated
several times in a short
period, this will cause a
Lifted error.
Turn power off.
Take Landroid to an area clear of obstacles, turn power on.
If the error message is still displayed: turn power off, turn Landroid
upside-down and check if there is any obstruction that would prevent the
front wheel casters from sliding into the mower body. When the mower is
lifted, the casters should drop down away from the mower body. When
placed back on level ground, the casters should slide back into the body.
Remove any obstruction if necessary, then turn the mower upright, and
power on.
Wire missing! Press
START to reset.
Machine can’t find
boundary wire signal.
If the LED light is red, check if the boundary wire is well connected to the
wire terminal clamps on the charging station.
If the problem persists, check that the boundary wire hasn’t been cut.
Battery temperature
out of range!
Please wait.
Temperature is too high
(more than 55
0
C)or
too low(less than 0
0
C)
when charging.
Place the charging station in a shady area or wait until it reaches the normal
temperature
Can’t find charge
station.
Press START to reset.
Boundary wire is
beyond its maximum
length (984 ft.).
Take Landroid to the charging station.
If the boundary wire length is beyond the rated limit, then the wire length
should be shortened.
