18
EN
MESSAGE
CAUSE
ACTION
Mower locked!
With the ‘Lock
Function’ enabled, if
your Landroid does
not receive a signal
from your Wi-Fi router
for 3 days, then it gets
locked as a security
measure.
This could be
because your router
lost its power or
because you changed
your Wi-Fi router or
network provider.
Please reconnect Landroid to the Wi-Fi network it has been originally paired
with.
If this is not possible, contact Cutomer Service.
NOTES
• Before turning power on, always check Landroid is inside its working area. If not, the message “Outside working area! Press START to
reset” will be displayed. This message is also displayed when Landroid is partly but not completely inside its working area.
• If for any reason—i.e. a party, children playing...—you want to park your Landroid in the charging station: press
then
.
Landroid will go to its charging station and stay there. Please note Landroid will now wait until the next scheduled mowing session. If you
want to re-start it at anytime, press
then
to start your Landroid.
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire so please refer to the
installation instructions and check your set up is correct.
• If your lawn is divided in two separated areas, connected by a corridor less than 3 ft. wide, one of which is not provided with the charging
station: when Landroid runs out of charge, take it manually to the charging station.
• If Landroid runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then restart it.
If the problem cannot be solved, please contact our Customer Service for help.
TROUBLESHOOTING
If your Landroid does not work correctly, follow the troubleshooting guide below. If the problem persists, contact Customer Service.
SYMPTOM
CAUSE
SOLUTION
The LED light on the charging
station does not turn on.
There is no power.
Check the charging station is connected properly to the charger
and the charger is connected to a suitable power supply.
Red light on the charging
station.
The boundary wire isn’t
connected.
Check that the boundary wire has been connected correctly to
the charging station. Check there are no breaks in the boundary
wire.
Landroid turns on, but the
blade disc does not spin.
Landroid is searching for the
charging station.
This is normal: when Landroid needs to recharge, the blade
disc does not rotate while it is searching for the charging station
automatically.
Landroid vibrates.
The blade disc is unbalanced.
Blades may be damaged.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade
disc.
