12
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The Forward and Reverse Switch, which is on top
of the trigger, is positioned in the lock function.
Unlock the Forward and Reverse Switch putting
it into the required rotation position. Push the
trigger and the drill will start to rotate. (See Fig. B)
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the Torque
Adjustment Ring, you can find the Torque
Adjustment Ring between the Chuck and the
drill body. Position 1 is the lowest torque (screw
driving force) and position 18/22 is the highest
torque (screw driving force). Position is for
drill operation. Position is for hammer drill
operation.Regulate the Torque Adjustment Ring to
a higher position to reach the best result.
(See Fig.E)
3. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot, the red LED Light
should turn on when the battery is charging.
4. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having
not used a Battery Pack for a prolonged time will
reduce the Battery Pack working time. This can
be corrected after several charge and discharge
operations by charging & working with your drill.
Heavy working conditions such as large screws
into hard wood will use up the Battery Pack
energy faster than lighter working conditions. Do
not re-charge your Battery Pack below 0
o
C and
above 30
o
C as this will affect performance.
MAINTENANCE
Remove the Battery Pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This
is normal and will not damage your power tool.
We recommend that you purchase your
accessories listed in the above list from the same
store that sold you the tool. Use good quality
accessories marked with a well-known brand
name. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.
