27
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book
carefully.
INTENDED USE
The power tool is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
ACTION
FIGURE
BEFORE OPERATION
Charging the Battery
NOTE:
1. Maximize Battery Performance
Prior to initial use, the battery must be
charged 5 hours to fully utilize the battery
capacity.
2. When the battery is full charged, the light
turns green.
See Fig. A
ASSEMBLY AND ADJUSTMENT
Inserting and Removing the Bit
Cartridge
See Fig. B,C
Assembling and Removing the Screw
Holder
See Fig. D1,D2
Installing and removing extendable flexible
shaft (optional)
See Fig. E1,E2
Forward/reverse/lock
WARNING:
Never change the direction
of rotation when the chuck is rotating,
wait until it is stopped!
See Fig F1,F2,F3
OPERATION
Selecting a Bit
See Fig G1,G2
Drilling a Pilot Hole
See Fig H
Assembling screw
See Fig I1,I2,I3
Tightening and Loosening Screw
See Fig J1, J2
Operating the On/Off Switch
WARNING:
Do not operate for long
periods at low speed because excess
heat will be produced internally.
See Fig K
LED Light Indicator
See Fig K
Automatic Spindle Locking
NOTE:
When the slide driver is out of
power, this function enables the customer
tightening or loosening screws manually.
MAINTENANCE
Your power tool requires no additional lubrication or mainte-
nance. There is no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean. Keep all
Summary of Contents for WX255
