6
Rotary hammer WX331 WX331.1 WX332
Wear eye protection
Wear dust mask
Before any work on the machine itself,
pull the mains plug from the socket
outlet.
Wear protective gloves
Concrete
High speed
Low speed
SDS-plus
Tool holder
Drilling
Chiseling
RCM approval mark
ABN: Australian Business Number,
according to which business details
such as business name and address
can be found at website http://abr.
business.gov.au
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for hammer drilling in
concrete, brick and stone as well as for light chiseling
work. It is also suitable for drilling without impact in
wood, metal, ceramic and plastic.
WARNING:
Before any work on the machine
itself, pull the mains plug.
OPERATION
Action
Figure
INSERTING AND REMOVING DRILL
BIT IN SDS
See Fig.
A1& A2
Adjusting the Auxiliary Handle
See Fig. B
Using the Depth Gauge
See Fig. C
Plugging in the power
See Fig. D
On/Off Switch With Variable Speed
Control
See Fig. E
FORWARD / REVERSE ROTATION
CONTROL
WARNING:
Never change the
direction of rotation while the tool is
rotating, wait until it has stopped.
See Fig. F
Selecting The Operating Mode
For simultaneous drilling and
impacting of concrete or masonry,
choose the Hammer drilling position.
For screw driving, drilling into steel,
wood and plastics choose the Rotary
drilling position.
For impacting only - for light
chipping, chiseling and demolition
applications choose the Hammer
position.
WARNING: The operating
mode selector switch may
be actuated only at a standstill.
WARNING: Prolonged use
will cause the aluminum
housing to become hot, do not
touch.
See Fig. G
WORKING HINTS FOR YOUR
DRILL (HAMMER)
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes