Worx WX543, Safety And Operating Manual

10

WX543 WX543.X

Cordless Jigsaw

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined 

according to EN 62841:

cutting boards

Vibration emission value 

ah,

B

9.134 m/s

2

Uncertainty K = 1.5m/s²

cutting steel 

metal

Vibration emission value ah,

M

=9.105 m/s

2

Uncertainty K = 1.5 m/s²

The declared vibration total value and the declared noise 

emission value have been measured in accordance with 

a standard test method and may be used for comparing 

one tool with another.

The declared vibration total value and the declared 

noise emission value may also be used in a preliminary 

assessment of exposure.

WARNING: 

 The vibration and noise emissions 

during actual use of the power tool can differ from 

the declared value depending on the ways in which the 

tool is used especially what kind of workpiece is 

processed dependant on the following examples and 

other variations on how the tool is used:

How the tool is used and the materials being cut or 

drilled.

The tool being in good condition and well 

maintained. 

The use of the correct accessory for the tool and 

ensuring it is sharp and in good condition.

The tightness of the grip on the handles and if any 

anti vibration and noise accessories are used.

And the tool is being used as intended by its design

and these instructions.

This tool may cause hand-arm vibration 

syndrome if its use is not adequately 

managed. 

WARNING: 

 To be accurate, an estimation of 

exposure level in the actual conditions of use 

should also take account of all parts of the operating 

cycle such as the times when the tool is switched off and 

when it is running idle but not actually doing the job. This 

may significantly reduce the exposure level over the total 

working period.

Helping to minimise your vibration and noise 

exposure risk.

Always use sharp chisels, drills and blades.

Maintain this tool in accordance with these 

instructions and keep well lubricated (where 

appropriate).

If the tool is to be used regularly then invest in anti 

vibration and noise accessories.

Plan your work schedule to spread any high 

vibration tool use across a number of days.

OPERATING INSTRUCTIONS

NOTE: 

Before using the tool, read the instruction 

book carefully.

INTENDED USE

The machine is intended for sawing wood, plastic, 

metal and building materials while resting firmly on the 

workpiece. It is suitable for straight and curved cuts. The 

saw blade recommendations are to be observed.

ASSEMBLY AND OPERATION

ACTION

FIGURE

BEFORE OPERATION

Removing the battery pack

See Fig. A1

Charging the battery

See Fig. A2

Installing the battery pack

See Fig. A3

ASSEMBLY

Blade Installation

NOTE:

 Ensure the blade is installed 

in place. The black line on the blade 

needs to be totally inserted into the 

tool-free blade holder.

See Fig. B1

Blade Removal

NOTE:

 Hold the blade with one hand 

when remove the blade.

See Fig. B2

Vacuum Adapter Installation

See Fig. B3

Vacuum Adapter Removal

NOTE: 

Press and hold the projection 

on the bottom of the vacuum adapter 

before pulling it out of the machine.

See Fig. B4

OPERATION

Pendulum Function

See Fig. C

Safety On/Off Switch

NOTE: 

For safety reasons the On/

Off switch of the machine cannot 

be locked; it must remain pressed 

during the entire operation.

Increasing or reducing the pressure 

on the On/Off switch  enables 

stepless stroke-rate control of the 

switched-on machine.

See Fig. D

Straight Cut and Curve Cut

See Fig. 

E1, E2