Worx WX543, Safety And Operating Manual

11

WX543 WX543.X

Cordless Jigsaw

Bevel Cut

NOTE: 

Remove the vacuum adapter 

before adjust the base plate.

NOTE: 

Rotate the base plate to the 

desired position according to the 

scale. Ensure the blade is engaged 

between the blade positioning wheel.

See Fig. 

F, G

Plunge Cut

See Fig. H

WORKING HINTS FOR YOUR 

JIGSAW

If your power tool becomes too hot, please run your 

jigsaw no load for 2-3 minutes to cool the motor. Avoid 

prolonged usage at very low speeds.

Always use a blade suited to the material and material 

thickness to be cut. For tight curves it is best to use 

a narrow saw blade. When sawing metal or similar 

materials, apply coolant/lubricant alongside the 

cutting line. 

Always ensure the workpiece is firmly held or clamped 

to prevent movement. Any movement of the material 

may affect the quality of the cut. The blade cuts on the 

upward stroke and may chip the uppermost. Ensure 

your uppermost surface is a non-visible surface when 

your work is finished.

For easier control, use low speed to start cutting and 

then increase to correct speed.

In order to avoid operation malfunctions, do not saw 

gypsum board from below or overhead.

The guide roller should occasionally be checked for 

wear and lubricated with a drop of oil. If it is worn, it 

must be replaced.

MAINTENANCE

Remove the battery pack from the tool before 

carrying out any adjustment, servicing or 

maintenance.

There are no user serviceable parts in your power 

tool. Never use water or chemical cleaners to clean 

your power tool. Wipe clean with a dry cloth. Always 

store your power tool in a dry place. Keep the motor 

ventilation slots clean. Keep all working controls free 

of dust. Occasionally you may see sparks through the 

ventilation slots. This is normal and will not damage 

your power tool.

FOR BATTERY TOOLS

The ambient temperature range for the use and 

storage of tool and battery is 0

o

C

-45

o

C

.

The recommended ambient temperature range for 

the charging system during charging is 0

o

C

-40

o

C

.

TROUBLESHOOTING

Symptom

Possible 

Causes

Possible Solution

The tool 

suddenly 

stops 

during 

operation.

Overload

Battery 

temperature 

too high

Relieve the load 

on the machine 

immediately and 

allow cooling for 

approx. 30 seconds 

by running the 

machine on no-load.

Low battery 

capacity

Charge the battery 

pack.

ENVIRONMENTAL 

PROTECTION

Waste electrical products must not be disposed 

of with household waste. Please recycle where 

facilities exist. Check with your  local authorities 

or retailer for recycling advice.

Positec Australia Pty Limited

10 Corporate Blvd Bayswater , VIC 3153, Australia