Finishing sander EN
11
allow the machine to cool down by running it
for approx. 3 minutes at maximum speed with
no load.
Sanding
work
Grain
Speed
setting
(opm)
Coarse
sanding
Preci-
sion
sanding
Sanding
down
var-
nishes
180
400
8700~12000
Strip-
ping
paint
40
120
9800~12000
Touch-
ing up
paint-
work
120
120
7600~10000
Sanding
wood
60
240
7600~12000
Machin-
ing
veneer
180
400
8700~11000
Sanding
alumini-
um
80
240
7600~11000
Derust-
ing
metal
40
120
9800~12000
Sanding
metal
and
steel
120
240
9800~12000
Sanding
plexi-
glass
180
400
6500~8700
3. cycLONIc DUST bOx (See Fig. D)
A) ATTAch ThE cycLONIc DUST bOx
Your sander is equipped with a cyclonic dust
box. To attach, slide the box onto the outlet
piece and take care that the latching lever
engages.
cAUTION:
To prevent the possibility
of sanding dust or foreign body being
thrown into your face or eyes, never attempt
to use your sander without the dust box
properly installed.
b) EmPTy ThE cycLONIc DUST bOx
(See Fig. D1 D2)
For more efficient operation, empty the
cyclonic dust box every 5-10mins. This will
permit the air to flow through the box better.
To empty the box, press the latching lever in
and pull off the box. Then press the button at
the rear of the box to open it, and shake out
dust.
4. USING ThE DUST ExTRAcTION
ADAPTER
Your sander is equipped with an adapter (4)
(See Fig. E), which is designed for connecting
the Cyclonic box. To attach the dust adapter
(11), you need firstly remove the adapter of the
sander (See Fig. F), and then insert the dust
adapter of the cleaner (See Fig. G), afterwards,
you can connect the vacuum cleaner.
If the vacuum hose is 35mm, insert the 35mm
dust adapter (11a) directly into the rear dust
outlet of sander (See Fig. G1).
If the vacuum hose is 32 mm, insert the 32
mm adapter (11b) into the back of 35mm
adapter (11a) (See Fig. G2).
First please turn on the vacuum cleaner, and
then turn on the sander. If you stop sanding,
first turn off the sander, then turn off your
vacuum cleaner.
5 FLUSh SANDING FAcILITy
Your sander can sand flush on three sides of
the base plate which allows easy access to
corners and edges of mouldings.
6 ORbITAL SANDING
Your sander operates in small circular
rotations which allow efficient material
removal. Operate your sander in long
sweeping movements across your work piece
and even across the grain. For a finer finish,
always use a fine grain sanding paper and
only move the sander in the direction of the
grit and never across the grain. Do not allow
your sander to remain in the same position
Summary of Contents for WX639
