7
Random orbit sander
EN
1. ON/OFF SWITCH
2. SOFT GRIP HANDLE
3. VARIABLE SPEED CONTROL
4. CYCLONIC DUST BOX
5. LATCHING LEVER
6. DUST EXTRACTION OUTLET
7. OUTER BASE PLATE
8. INNER BASE PLATE
9. MOTOR HOUSING
10. A: INNER SPOT PAPER*(SEE FIG A)
B: OUTER RING PAPER*(SEE FIG A)
11. DUST EXTRACTION ADAPTOR(SEE FIG D)
* Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type
WX655 (650~659-designation of
machinery, representative of Random orbital
sander)
Voltage
230V~50Hz
Power Input
380W
No-load speed
6000-13500/min
Base size
125mm
Orbital diameter
3mm
Protection class
/ll
Machine weight
1.7kg
NOISE INFORMATION
A weighted sound pressure
L
pA
: 80.2dB(A)
A weighted sound power
L
wA
: 91.2dB(A)
K
pA
& K
wA
3.0dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 60745:
Typical weighted
vibration
Vibration emission value
a
h
= 3.925m/s
2
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING:
The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed
WARNING:
To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
°
C or less
Plan your work schedule to spread any high vibration
tool use across a number of days.
Summary of Contents for WX655
