10
EN
12V Multifunction Jump Starter with LED
Lights
4.LIGHTING
The jump starter features several different work light modes through pressing on the power button for
different times:
1. First Power Button press turns the unit ON, indicating the unit’s state of charge.
2. Second press turns ON solid working light.
3. Third press turns ON solid red signal light.
4. Fourth press turns ON flashing red signal light.
5. Fifth press turns ON solid flashlight.
6. Sixth press turns ON flashing flashlight.
7. Seventh press turns entire unit OFF.
NOTE:
While in any of the above work light modes, you can turn the unit OFF by pressing and holding the
Power Button for four seconds. The power indicator will automatically turns off after 10 minutes.
TROUBLE SHOOTING
1. The indicator light does not show when charging the device
1) Check that the charging cable is actually connected to the device.
2) Check if the port is correctly connected.
2. Flashlight can’t open
1) Check if the device has enough charge for use.
2) Check that it is used correctly.
3. Unresponsive when using the device
1) Charge the device, when charging, the light flashes.
2) If an emergency start is given to a car device with low battery capacity, the start is not valid due to the
activation of the chip safety protection function. It can be reset by charging it to be reactivated.
MAINTENANCE AND STORAGE
Your tool requires no additional lubrication or maintenance. Never use water or chemical cleaners to clean
your charger. Wipe clean with a dry cloth. Always store your charger in a dry place.
Long time not used, it is recommended to maintain a certain capacity of the battery.
PRECAUTIONS
1) The applicable temperature for use -17
o
C -60
o
C
2) Avoid direct sunlight or humid conditions.
3) Avoid the switch being squeezed when placed.
4) If circuit protection is caused by plugging in high-power 12V vehicle equipment (current more than 8A),
charge the emergency power supply to activate it.
FCC PART 15
Supplier’s Declaration of Conformity
Product Description : 12V multifunction Jump starter with LED Lights
Model Number : WX852L
Trade Name : Worx
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Responsible Party :
Positec USA, Inc.
10130 Perimeter Parkway, Charlotte, NC 28216 USA
Tel.: (704) 599-3711
Fax: (704) 599-6390
