5
USING THE CHIP SMARTBAND™
When you first power up the CHiP SmartBand™, CHiP™ will respond by tracking and driving towards it.
POWERING THE CHiP SMARTBAND™
* The CHiP SmartBand™ is operated by 1 x 3.7V 130 mAh
Lithium-ion rechargeable.
DC IN 5V 0.5A
TURNING ON THE CHIP SMARTBAND™
LOW BATTERY INDICATORS
To get started with the CHiP SmartBand™, Press and hold the "CHiP™"
button in the middle of the band for 2 seconds then follow the instructions
in the "Playing With CHiP™" section of this instruction manual.
To power off, press and hold the "CHiP™" button for 4 seconds.
When the battery grow weak, CHiP SmartBand™ will
flash PURPLE and then power down. When this happens,
recharge CHiP SmartBand™ as indicated below.
POWERING THE CHIP SMARTBAND™:
1. Plug the Micro USB Cable into the Micro USB port
on the CHiP SmartBand™ and connect to a power
source as indicated in the diagram.
2. Charging is indicated by a flashing PURPLE light.
3. When fully charged, the LED light on the
CHiP SmartBand™ will remain PURPLE (no
longer flashing).
4. Press the center button on CHiP SmartBand™ to
reactivate the band.
ON
OFF
IMPORTANT BATTERY INFORMATION
• Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries, different types of batteries
[standard (Carbon-Zinc), Alkaline or rechargeable] or
rechargeable batteries of different capacities.
• Remove rechargeable batteries from the toy before
recharging them.
• Rechargeable batteries are only to be charged under
adult supervision.
• Please respect the correct polarity, (+) and (-).
• Do not try to recharge non-rechargeable batteries.
• Do not dispose of batteries into fire.
• Replace all batteries of the same type/brand at the same time.
• The supply terminals are not to be short-circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults.
• Batteries should be recycled or disposed of as per state and
local guidelines.