1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
Battery
Compartment
battEry EtaiLs an pOWEring On
Battery requirements
Your remote controller is powered by 3 x “AA” size batteries
(not included).
Your Roboreptile is powered by 6 x “AA” size batteries
(not included).
Battery installation
1
Before installing or changing batteries, ensure the Roboreptile’s
ON/OFF button is in the OFF position.
2
Remove the battery compartment covers using a Phillips
or crosshead screwdriver (not included).
3
Insert batteries (not included) into the Roboreptile and
controller as shown in the diagrams.
4
Replace the battery compartment covers and the screws.
5
Press the ON/OFF button to the ON position.
Attention: Important Battery Information
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, different types of batteries [standard (Carbon-Zinc),
Alkaline or rechargeable] or rechargeable batteries of different capacities
• Remove rechargeable batteries from the toy before recharging them
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
• Do not throw batteries into the fire
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not be short-circuited
• Remove exhausted batteries from the toy
• Batteries should be replaced by adults
• Remove batteries if the toy is not going to be played with for some time
Bottom view of Roboreptile controller
Powering ON
Roboreptile will perform a start-up
routine which cannot be interrupted;
he will then wait for interaction.
If no interaction occurs for about
30 seconds, Roboreptile will
enter Free Roam Mode (see p.5).
Bottom view of Roboreptile
Press once to
turn power on
Battery
Compartment
On
Off
1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA”
