1080p IP Streaming Encoder/Decoder
20
5.5 Audio Routing Tab
The "Audio Switching" tab is used to setup and manage audio routing between TX and
RX devices.
All the RX devices are listed in the top half of the Decoder (RX) section. Similarly, all
the TX devices are listed in the bottom half in the Encoder (TX) section.
First, verify if appropriate TX and RX devices are joined:
1) Verify that the Decoder (RX) is currently joined with the desired Encoder (TX).
a) Click on the RX and the Encoder (TX), it will be highlighted in blue when joined
to.
b) Selecting the respective encoder will highlight all the decoders joined to the
same TX.
2) If the respective Encoder (TX) is currently not joined to the Decoder (RX), join them
together:
a) In the Encoder (TX) section, select a TX by clicking on its associated active tile.
b) Drag and drop the TX tile onto the RX tile to which it is attached.
c) TX and RX are now joined together.
d) Repeat above steps if additional decoders are to be joined to the same TX.
