MRTALP4-DC3: #35058
Rev 7.4/12-21
12
Repositioning Vacuum Pads
1)
1A
Remove the cotterless hitch pin (fig. 1A) that secures a
sliding/movable pad mount to the pad frame.
2) Position the pad mount as required on the T-arm
assembly.
3) Use the cotterless hitch pin to secure the pad mount.
Repeat these steps to position other pad mounts as needed.
Repositioning T-Arm Cross Members
When more precise pad alignment is needed (eg, on contours of insulated panels), the cross
members of the T-arm assemblies can be repositioned as follows:
1)
1B
Remove the bolts (fig. 1B) connecting a cross member.
2) Move the cross member to the appropriate position.
3) Reinstall the bolts and tighten them securely.
Repeat these steps to reposition the other cross member.
ASSEMBLY
