Rev 19.1/7-22
MTA2-AC: #35098
11
T
O
A
TTACH
THE
P
ADS
TO
A
L
OAD
Generating Airflow
Place the power switch in the “on” position (
), to engage the vacuum
pump.
Keep pump running
throughout lift.
The lifter is designed for the vacuum pump to run continuously. Placing the
power switch in the “off” position (
) during lifter operation could result
in a load release and personal injury (see
Positioning the Lifter on the Load
1)
1A
Make sure the contact surfaces of the load and vacuum pads
are clean (fig. 1A; see
2)
2A
Center the pad frame on the load (fig. 2A).
1
1..... The lifter is designed to handle the maximum load weight when the load’s center of gravity is positioned within 2" [5 cm] of the pad frame’s
center point. Uncentered loads may tilt unexpectedly.
OPERATION
Summary of Contents for MTA211LAC
Page 2: ...MTA2 AC 35098 Rev 19 1 7 22 2...
Page 31: ...Rev 19 1 7 22 MTA2 AC 35098 29...
Page 32: ...MTA2 AC 35098 Rev 19 1 7 22 30...
