Rev 4.0/2-21
P1-DC3: #35123AUS
21
A
FTER
U
SING
THE
L
IFTER
1)
1A
Press the power button ( , fig 1A) and the “function”
button ( , fig. 1A) to power down the vacuum lifter.
2) Charge the battery after each workday as needed (see
).
1
3) Use the hoisting equipment to lower the lifter gently onto
a stable support. Then detach the hoisting hook from the
lift point.
3A
Caution:
Do not set lifter on surfaces that could soil or
damage vacuum pads
.
If the lifter has VPFS10T pads,
protect their sealing rings by making sure each pad rests
on spacers.
2
Note: A control handle can be used to support an
unloaded lifter when not suspended (fig. 3A). Make sure
the lifter leans securely against an appropriate support
that does not contact the vacuum pads.
Transporting the Lifter
Secure the lifter in the original shipping container with the
original shipping materials or equivalent.
1..... To maximize battery life, charge it promptly after each use.
2..... If the lifter has VPFS10T pads, cardboard spacers are integrated into the original shipping container. Similarly shaped spacers should be used
when setting the lifter on other surfaces.
OPERATION
