WPI A310 Accupulser, Instruction Manual

A310 Accupulser™ Pulse Generator

World Precision instruments

9

outPut ..............................A green light, which is illuminated during the length of 

the Pulse WidtH and the trAin durAtion. the light 
may not be visible when short pulses are generated with 
large intervals between pulses. the light will appear to be 
continuously on when pulses are generated with very short 
intervals between pulses.  

sYnc ....................................A Bnc connector used to provide a narrow pulse at the 

beginning of each eVent interVAl. the signal on the 
center pin is positive relative to the connector shell.

isolAtor ...........................A Bnc connector used to provide output pulses in 

accordance with the preset timing parameters. the signal on 
the center pin is positive relative to the connector shell. this 
output is compatible with WPi stimulus isolators.

monitor ...........................A Bnc connector used to provide output pulses in 

accordance with the preset timing parameters. the signal on 
the center pin is positive relative to the connector shell.

Power 

PoWer light ......................A green light, which is illuminated whenever mains power is 

connected to the instrument and the PoWer switch is on.

PoWer switch ...................A two-position switch used to apply mains power to the 

instrument.

Rear Panel

connector ...........................Polarized, 3-conductor, iec30/cee- connector is used 

for line (mains) power input to the instrument. A removable 
cordset, terminated with a nemA 5-5P connector, is 
standard. An alternate cordset may be supplied when 
local circumstances dictate different mains voltages and 
connections. 

Fuseholder ..........................used for protective fuse in series with the high side (brown 

or black wire) of the mains. Holder accepts / by -/ inch 
(.35mm by 3.8mm) fuses of the type indicated on the rear 
panel.