WPI A310 Accupulser, Instruction Manual

A310 Accupulser™ Pulse Generator

World Precision instruments

PREPARATION FOR USE

this section describes the initial preparations required when the A30 Accupulser™ 
is first placed into operation. review the safety guidelines on pages -5 before 
proceeding.

Shipping Information

the A30 Accupulser™ is packaged and shipped in a foam-packed container. this 
manual and any options will be included with the instrument. upon receipt of 
the the instrument, make a thorough inspection for proper contents and possible 
shipping damage. if reshipment is necessary, use the original container. if the original 
container is not available, use any suitable substitute that is rigid and of adequate 
size. Wrap the instrument in paper and surround with at least 00 mm (four inches) 
of shock absorbing material.

Installation

Input Power

CAUTION: 

the A30 Accupulser™ may be damaged if the line Voltage 

selector switch is not set to match the applied Ac power source or the wrong 
line fuse is installed.

this instrument operates from either a 0V or 0V nominal Ac power source. the 
rear panel is marked at the factory with the user’s expected mains power. Before 
connecting the power cord, verify that, in fact, the correct mains power setting was 
provided and the appropriate line fuse is installed. if any doubt remains, the internal 
line Voltage selector switch may be adjusted.

Warning: Before removing the cover, disconnect the instrument from the 
ac power source.

the switch is located inside the instrument. to verify the voltage setting:

. remove the four screws (two on each side) on the side panels of the top cover.

. remove the instrument cover by sliding it straight upward.

3. Find the power supply printed wiring board next to the right side of the instrument.