12
o
IMPORTANT: The vent at the base of the appliance is for ventilation. Nothing should be placed in front
of this vent; otherwise your wine cooler may not operate properly.
o
A decorative plinth can be fitted to the front of the base vent as long as the cut out shown in the diagram
below is made in the plinth. This cut out is required whether the vent is removed or not.
Adjusting the height and leveling of your wine cooler
o
The appliance is equipped with adjustable feet, so that the height may be adjusted to level the cooler on
uneven floor surfaces.
o
We recommend that two people carry out this procedure.
o
The height must be adjusted prior to building the appliance into the housing unit and it should be set at
such a height that the top panel of the appliance fits exactly below the kitchen worktop.
o
The appliance height is 865mm when produced in factory,can adjust height from 865-920mm by adjusting
the feet.
o
Pull down the appliance carefully approximately 60° to allow access to the adjustable feet.
o
Take care to ensure the cooler is supported at all times.
o
Twist the foot into a suitable position to level the cooler from 870 to 920mm.
o
Repeat these steps for the other adjustable feet.
IMPORTANT: If the appliance is not level, then the door and door seal may be affected.
