S-32
05-E2B, 05-E2BG, WSM
DIESEL ENGINE
Thermostat Assembly
1. Remove the thermostat cover mounting screws (1), and remove
the thermostat cover (2).
2. Remove the thermostat assembly (4).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) only at the
thermostat cover side of the gasket (3).
W10363950
(4) Gear Case and Timing Gears
Fan Drive Pulley
1. Secure the flywheel to keep it from turning.
2. Remove the fan drive pulley screw.
3. Draw out the fan drive pulley with a puller.
(When reassembling)
• Install the pulley to crankshaft, aligning the mark (1) on them (3-
cylinder engine).
• Apply engine oil to the fan drive pulley retaining screw. And
tighten it.
W10181950
(1) Thermostat Cover Mounting Screw
(2) Thermostat Cover
(3) Thermostat Cover Gasket
(4) Thermostat Assembly
Tightening torque
Fan drive pulley screw
235.4 to 245.2 N·m
24.0 to 25.0 kgf·m
173.6 to 180.8 ft-lbs
(1) Aligning Mark
KiSC issued 06, 2011 A