Warner Shelter Systems Limited
PAGE 2
Table of Contents
Tent Location
1.)
TENT LOCATION................................................................................................
2
2.)
PARTS LIST AND PARTS NUMBER
.................................................................. 3
3.)
FRAME ASSEMBLY
........................................................................................ 4-5
Post & Centrepole Assembly .................. Step 2....................... PAGE
4
Upper Frame Assembly ......................... Step 3....................... PAGE
4
Cross Cable Installation ......................... Step 4 & 5 ................ PAGE
4
Cable: Slide Wall Installation (optional)
... Step 6....................... PAGE
5
4.)
TENT TOP INSTALLATION
................................................................................. 5
Protecting Tent Top ................................. Step 7....................... PAGE
5
Unfolding Tent Top ................................. Step 8 ...................... PAGE
5
Securing Tent Top to Frame ................... Step 8A/8B .............. PAGE
5
5.)
ERECTING THE TENT
................................................................................... 6-7
Installing Posts ....................................... Step 9 ...................... PAGE
6
Installing Centrepole ............................... Step 10 & 11 ............ PAGE
6
Securing the Structure ........................... Step 13 & 14 ........... PAGE
7
6.)
WALL INSTALLATION
......................................................................................... 8
7.)
JOINER INSTALLATION
............................................................................... 9-10
8.)
SUMMARY
........................................................................................................ 10
9.)
CARE FOR YOUR VINYL TOPS
..................................................................... 11
10.)
MAINTENANCE
............................................................................................... 11
VERY IMPORTANT!
Ascertain tops, guys, and other tent parts are in good operating condition. Any
components showing damage should be replaced immediately.
Before unloading, review the proposed location of the tent. In doing so, take into
account the following:
Hazards
Locate, mark, and avoid any overhead or underground electrical, phone, gas,
sprinkler or other lines. Take note and always be aware of any and all hazards. DO
NOT BEGIN ANY ASSEMBLY UNTIL THE HAZARDS HAVE BEEN MARKED AND
CAN BE SAFELY AVOIDED.
Access
Plan the best route for bringing the tent and equipment for the setup onto and off
the site.
Drainage
Attempt to influence the location of the tent so that rain or melting snow can drain
away.
Obstacles
A clean, level and unobstructed site will provide an easy assembly of the tents.
Weather
Do not attempt to setup the tent during thunderstorms, high winds or other extreme
conditions.
Safety
Before the set up, instruct the crew on safety procedures. All local safety and fire
regulations must be followed.
ALL SITE PERSONNEL MUST FOLLOW OCCUPATIONAL HEALTH AND SAFETY PROCEDURES.
PAGES
..\graphicshome\Marquee\Manuals\MQ1020\MQ1020 Manual 2007.FH11
