Warner Shelter Systems Limited
PAGE 6
Step 10
• After raising one side, push Drop Sheet towards
the lower half of the frame to expose the Cable
intersection.
• Insert the Centrepole through the socket at the
centre of the Tent Top and lean the Centrepole
against the intersection of the Cross Cable.
• Install the Flag on the Centrepole from the outside.
CENTREPOLE INSTALLATION
* Be careful when stepping on fabric. Removing shoes would be recommended to avoid soiling or damaging the Tent Top.
Step 11
• Place the Centrepole sleeve on the top
Cable and slide to the intersection of the
Cross Cables, wedging the Centrepole
between the cover and the cables.
• At the intersection, push down bottom cable
while pulling up the top cable to set both
cables directly below the Centrepole sleeve.
• Secure the Centrepole to the
cables using the Lock-Pin.
Top Cross
Cable
Bottom Cross
Cable
Step 9
• Lock post in place
using lock-pins. =>
INSTALLING POSTS
• To install the first Post, lift one corner and
slide the Post into the Corner sleeve.
SEE DRAWING 9:1
DRAWING 9:1
ERECTING THE TENT
Centrepole
Sleeve
Lock Pin
Cross
Cables
..\graphicshome\Marquee\Manuals\MQ1020\MQ1020 Manual 2007.FH11
Lock pin
Corner
Sleeve
Post
DRAWING 9:2
• Insert s-hook at the bottom of the tension strap
into the hole in the Base.
SEE DRAWING 9:3
• Tension strap by pulling the strap down.
• Repeat procedure for the second post.
=>
DRAWING 9:3
S-hook
Tension strap
Catenary Cord
Quick Link
IMPORTANT!
Legs must move inward
as other legs are raised.
Cam buckle