Warner Shelter Systems Limited
PAGE 8
BATON
WALL
5. If two or more walls are to be installed, fasten velcro
strips on the edges of the walls from top to bottom for
a clean seal.
STANDARD
WALL
Wall Installation
* Before installing walls, make sure toggle ropes
are evenly tensioned and the Tent Top is evenly
positioned on the frame.
Check if Cable: Slide Wall is properly tensioned.
Tighten with turnbuckle if needed.
1. Clip walls to Cable: Slide Wall as shown
below.
2. Slide the wall towards the other end. =>
3. Secure top wall strap wall straps to Eve Tube.
4. Secure side wall straps to Posts. Evenly
tension straps. =>
* Walls are available with
Delrin side release or
steel buckles.
* Walls with batons are
equipped with side
release buckles or
velcro straps.
Baton
Post
Side Release Buckles
Steel Buckle
Velcro
Cross Cable
Cable:
Slide Wall
Turnbuckle
..\graphicshome\Marquee\Manuals\MQ1020\MQ1020 Manual 2007.FH11
